nav emailalert searchbtn searchbox tablepage yinyongbenwen piczone journalimg journalInfo searchdiv qikanlogo popupnotification paper paperNew
2015, 01, v.14;No.52 16-22
微自由活塞动力装置参数设计的数值模拟
基金项目(Foundation): 国家自然科学基金项目(51476071);; 江苏高校优势学科建设工程项目(苏教材〔2011〕8号);; 江苏大学高级人才科研启动基金项目(14JDG146)
邮箱(Email):
DOI:
摘要:

随着微燃烧室尺寸的缩小,微自由活塞动力装置结构参数的微小变化会影响其工作稳定性及输出功率的大小.为了开发出性能优良的微动力装置,结合动网格技术,采用FLUENT软件对微自由活塞动力装置参数设计进行了数值模拟计算.研究结果表明,当微燃烧室体积为212 mm3时,活塞获得的压缩初动能应略大于临界压缩着火初动能值0.2 J,均质气体可以压缩燃烧,且活塞运行过程最为稳定;在相同压缩初动能条件下,活塞质量为1 g时,活塞动能增量最大,且微动力装置工作比较平稳;当微燃烧室体积为212 mm3,直径为4 mm时,微动力装置更容易启动,且输出功率最大.

Abstract:

With the decrease in size of micro combustion chamber, the tiny change of micro free-piston power device structure parameters could affect the working stability and the power output. In order to develop micro power device with excellent performance, the numerical simulation combined with the technology of dynamic mesh was performed to study the parameter design of micro free-piston device by FLUENT. The results showed that, the homogeneous gas could be compressed to combust when the piston compression initial kinetic energy is a little higher than the critical one which is 0.2J, and the piston running process is the most stable when the micro-chamber volume is 212 cubic millimeter. Besides, the piston kinetic energy increment is the maximum and the micro-power-device running is relatively stable when the piston mass is 1g under the same compression initial kinetic energy condition. And the results also indicated that the micro power device can be easier to start and the output power can reach the maximum when the micro-chamber diameter is 4mm.

参考文献

[1]夏必忠,傅新,杨华勇.液压自由活塞发动机的能量平衡分析[J].内燃机工程,2002,23(3):76-80.

[2]Aichlmayr H T,Kittelson D B,Zachariah M R.Micro-homogeneous charge compression ignition(HCCI)combustion:investigations employing detailed chemical kinetic modeling and experiment[R].University of Minnesota Supercomputing Institute Research Report,2001.

[3]王谦,李德桃,施爱平.自由活塞式发动机NOx排放的数值计算研究[J].内燃机学报,2001,19(6):562-566.

[4]Clark N,Mc Daniel T,Atkinson R J,et al.Modeling and development of a linear engine[C]//Proceedings of ASME Spring Conference,Internal Combustion Engine Division,1998,30(2):49-57.

[5]Clark N,Nandkumar S,Famouri P.Fundamental analysis of a linear two-cylinder internal-combustion engine[R].SAE Technical Paper,1998.doi:10.4271/982692.

[6]Mikalsen R,Roskilly A P.The control of a free-piston engine generator.part 1:fundamental analyses[J].Applied Energy,2010,87(4):1273-1280.

[7]Mikalsen R,Roskilly A P.The control of a free-piston engine generator.part 2:engine dynamics and piston motion control[J].Applied Energy,2010,87(4):1281-1287.

[8]Mohamed N A N,Ariffin A K,Fonna S.Simulation of a two-stroke spark ignition free piston linear engine motion[J].Jurnal Teknologi,2006,44(1):27-40.

[9]Achten P A J,Van Den Oever J P J,Potma J,et al.Horsepower with brains:the design of the Chiron free piston engine[R].SAE Technical Paper,2000.doi:10.4271/2000-01-2545.

[10]Tikkanen S,Lammila M,Herranen M,et al.First cycles of the dual hydraulic free piston engine[R].SAE Technical Paper,2000.doi:10.4271/2000-1-2546.

[11]Aichlmayr H T,Kittelson D B,Zachariah M R.MicroHCCI combustion:experimental characterization and development of a detailed chemical kinetic model with coupled piston motion[J].Combustion and Flame,2003,135(3):227-248.

[12]Sher I,Levinzon-sher D,Sher E.Miniatur ization limitations of HCCI internal combustion engines[J].Applied Thermal Engineering,2009,29(2/3):400-411.

[13]栾延龙,李理光,王哲,等.自由活塞发动机关键设计参数及其性能的仿真优化研究[J].内燃机工程,2010,31(2):15-21.

[14]李庆峰,肖进,黄震.两冲程HCCI自由活塞式内燃发电机仿真[J].农业机械学报,2009,40(2):41-45.

[15]刘艳,王谦,谢强,等.二甲醚燃料微动力装置内HCCI试验研究[J].工程热物理学报,2014,35(4):814-818.

[16]柏金,王谦,何志霞,等.微自由活塞发动机HCCI着火界限研究[J].机械工程学报,2013,49(20):192-198.

基本信息:

DOI:

中图分类号:TK401

引用信息:

[1]柏金,王谦,刘庆等.微自由活塞动力装置参数设计的数值模拟[J],2015,14(01):16-22.

基金信息:

国家自然科学基金项目(51476071);; 江苏高校优势学科建设工程项目(苏教材〔2011〕8号);; 江苏大学高级人才科研启动基金项目(14JDG146)

检 索 高级检索

引用

GB/T 7714-2015 格式引文
MLA格式引文
APA格式引文